Advantage
1.The roller is made of chilled casting vanadium & titanium alloy iron which is hard and wear-resisting, the surface hardness is above 70degree, the surface coating is about 15mm.
2.Hard tooth gear reducer with well-design structure, low noise, high efficiency and long service life.
3.Self-aligning bearing is well matching with the bearing inside leakage-proof device. The sealers are made of high temperature,wear, oil resistance material,which have very good sealing effect.
4.All main electrics are imported, the alternating current contactor is Shilin brand. The switch and button are Taiwan Tend brand.
5.Circulating lubrication system solves the oil leakage problem. The feature of this system is easy to maintain,easy to replace.
6.This machine is installed with overload protection device which protect the machine will not broken if the machine is overload.The machine will reverse 1/3 round when press the emergency stop button,which sure the production safety.
7.The“U” shape frame is whole set casting, but other factory welded together.
8.The machine base is welded by national standard I steel.
Main parameter
| Mixing capacity(L) | 75 |
|---|---|
| Motor power | 110KW 6P AC |
| Material feeding | Front/back |
| Temperature adjustment | Steam heating or water cooling |
| Mixing capacity per batching | About 70-80kgs/time |
| Mixing time | 4-8mins/batching |
| Rotor RPM | RPM/RPM |
| Temperature difference | ±5o |
| Gear reducer | ZLY375 |
| Gear width | Input 110mm,output 140mm |
| Tilting angle | 140° |
| Main air cylinder size (mm) | 360×900 |
| Piston rod diameter (mm) | 120 |
| Mixing chamber size (mm) | 610×600×725 |
| Two rotors center to center space (mm) | 610×600×725 |
| Mixing capacity per batching | About 70-80kgs/time |
| Motor power | 110KW 6P AC |
| Material feeding | Front/back |
| Temperature adjustment | Steam heating or water cooling |
| Mixing capacity per batching | About 70-80kgs/time |
| Mixing time | 4-8mins/batching |
| Rotor RPM | RPM/RPM |
Public equipment
Power: 380V 50Hz
Cooling water supply: 2kg/cm2 0.4cbm/min
Machine parts
Machine frame: one
Transmission drive: one
Nip adjustment device: one
Pipes: one
Electrics: one
Machine structure
（1）Units
| Machine base | Welded by national standard I steel and steel plate. |
|---|---|
| Machine frame | Carbon steel casting with thermal treatment. |
| Rollers | Roller is made of chilled casting vanadium & titanium alloy iron which is hard and wear-resisting. With special treatment to the inside,the temperature of roller surface will be even.? |
| Bearing | SKF self-aligning bearing, CC model, which has long service life. |
| Bearing base | whole set casting |
| Leakage-proof device | Imported high temperature and wear resistance oil seal. |
（2）ransmission drive
| Main motor | 18.5KW，6P, AC |
|---|---|
| Coupling | Main motor and reducer are connected by coupling. |
| Reducer | Hard tooth with precision processing. |
| Ratio gear | Front and back rollers are connected by ratio gear. |